Connecting Your Irrigreen Sprinkler to a Different Controller Cable


In this article, we will walk you through moving your Irrigreen Sprinkler to the opposite controller cable. Before beginning

be sure you have an extra controller cable for your other terminals.

Installation Made Easy

Experience the revolutionary Irrigreen system that's easy to install and maintain. Irrigreen is the only in-ground system that is designed with DIY in mind.


Not ready to take on Installation, no problem. We have a network of contractors we can connect you with.

Step by Step Guide

Step 1


Step 2


Step 3


Step 4


Step 5


Step 6


Step 1: Remove Sprinkler From the App

  • Open the app and go to the Zones Page.
  • Find the Zone you want to move to the opposite controller cable and click 'Edit Shape.'
  • Once the map appears on the screen, click the large gear icon in the upper right corner.
  • An option will be available in red to 'Blank Head,' click that. This will clear this sprinkler from its assigned Zone.

Step 2: Connect Sprinkler to the Different Controller Cable

  • Unplug the sprinkler from its location in the yard, ensuring that you seal off connection with an Irrigreen End Plug or connect the sprinkler cables with one of our CableLok Clamps.
  • Connect the sprinkler to the other controller cable.
    • Ensure all connections are secure with arrows aligned and CableLok clamps tight.  

Step 3: Add Sprinkler to the App

  • Open the app again and go to the 'Zones' tab. Click the + icon in the top right corner.
  • The controller will scan all cables for blank sprinklers. The newly blanked sprinkler will appear as "IGSprinkler-xxxx."
  • Standing near the blanked sprinkler, click 'Identify.'
  • In a few seconds, your sprinkler's green cap will begin rotating back and forth underground.
  • Once you've confirmed it spins, click the hollow circle to the left of the "IGSprinkler-xxxx" name, filling it with a check mark.
  • Click 'Done.' Your sprinkler has now been successfully moved to a new controller cable.
  • Go back into the Zone page and click into the sprinkler page that you just added. Click the gear icon and select 'Re-do Calibration.'
  • Your sprinkler will run through the calibration process. After this is done, you can set your new map and save!

Not finding what you’re looking for?  

Please contact our Customer Service Support (Monday - Friday 8AM-5PM CST):